Simply Supported Beam with Distributed Load Calculator for simply supported beam with uniformly, uniformly varying, trapezoidal, triangular and partially distributed loads.
Note : Use dot "." as decimal separator.
Note * : w_{a} and w_{b} are positive in downward direction as shown in the figure and negative
in upward direction.
Note ** : For second moment of area calculations of structural beams, visit "
Sectional Properties Calculators".
RESULTS 
Parameter 
Value 
Reaction Force 1 [R_{1}] 



Reaction Force 2 [R_{2}] 


Transverse Shear Force @ distance x [V_{x}] 


Maximum Transverse Shear Force [V_{max}] 


Moment @ distance x [M_{x}] 



Maximum Moment [M_{max}]蜜蜂视频app污下载
蜜蜂视频app污下载
,经典日韩剧在线观看
经典日韩剧在线观看
,乖进去就不一疼了 再深点
乖进去就不一疼了 再深点



Slope 1 [θ_{1}] 



Slope 2 [θ_{2}] 


Slope @ distance x [θ_{x}] 


Maximum Slope [θ_{max}] 


Deflection @ distance x [y_{x}] 



Maximum Deflection [y_{max}] 


Bending Stress @ distance x [σ_{x}] 



Maximum Bending Stress [σ_{max}] 


Note * : R_{1} and R_{2} are vertical end reactions at the left and right, respectively, and are positive upward. Shear forces and deflections are positive in upward direction and negative
in downward direction. All moments are positive when producing compression on the upper portion of the beam cross
section. All slopes are positive when up and to the right.
Note: Stresses are positive numbers, and these are stress magnitudes in the
beam. It does not distinguish between tension or compression of the structural
beam. This distinction depends on which side of the beam's neutral plane c input
corresponds.
Slope
Deflection
Moment
Shear Force